Review Beltronics STi R Remote – Part One
Beltronics STIr Install SUV
Several weeks I was honored as being one of the first to review the new Beltronics STI-r radar detector.
The STI-r is the first remote mounted detector that is not only capable to be invisible to the eye but also invisible to all the radar detector detector units such as the Spectre III and IV. This ability is an important feature where radar detectors are illegal such as in Virginia, Washington DC, in all commercial vehicles weighing over 10,000 pounds and in various provinces in Canada.
We first installed the STI-r into a 2007 Toyota Sequoia.
As the STI-r antenna serves as both the radar detector and laser antenna it is important to mount the antenna in a fashion that the front laser sensors are not blocked and to be positioned in the front grill area where officers commonly target their laser guns.
We choose to use heavy duty double sided 3M automotive double sided tape that is available through NAPA and not the supplied antenna mount, so we wouldn’t need to drill into the front bumper area. We mounted the antenna below the front bumper in the bottom grill.
We then ran the antenna cable through the engine compartment, through the firewall to the rear dash. We removed the Toyota’s car radio utilizing a special screwdriver that allowed the radio to slide out, and installed the main interface under dash.
We then plugged the front antenna, display module, controller module and external speaker into the interface.
We mounted the external powered speaker under the dash and ran mounted the small LED display above the steering column just below the Toyota’s instrument panel and mounted the control module below the steering column on the right lower dash.
I really appreciated the two part LED and controller and their small size, as I was allowed to mount the LED display closer to the main instrument panel. The LED display also has a photo sensor installed to the front that allows it to automatically adjust for brightness.
Both the control module and the LED display has double sided tape applied to them, so it is basically peal and stick, making for an easy install of these two parts.
The STI-r also includes an in dash bezel and a single in dash LED light display for those who really want to go to the next step in making their unit stealth to the eye.
The final step in our install was to run the power cables from the speaker and the interface to the controller and power up.
I’ve installed countless remote mounted radar detectors but I have to admit, I found the STI-r one of the easiest as their documentation was easy to read and understand. The total install time took 90 minutes with the biggest challenge finding a location where I could run the antenna cable through the firewall utilizing an existing cable run.
We will be running the STI-r through its paces this weekend in the Toyota and then we will be re-installing it in a Freightliner tractor for an extended road trip through Nevada next week and we will provide an update on our road test when we return.
4 Responses to “Review Beltronics STi R Remote – Part One”
Comments
Read below or add a comment...
very nice i like the sound of this
it sounds good lets hope it’s not expensive like the current sti
i want one too but i just bought a sti back in sept and i can’t afford one @ that price
again
Looking for information and found it at this great site… Bel radar detectors 975r
They have barely any if at all for false alarms from my knowledge from what I was told from them.. but he was picking me up a pretty good distance.. I'm saving up for a Bel Sti-R currently – they look promising. accept they need a Rear mounted radar/laser system…. but that cost alittle extra which will be worth it. Not looking forward too all the wires but oh well. undetectable is undetectable, right?